A couple of pictures

By-products from writing documentation….

2
Image copyright 2005 Tim Warris

While writing the documentation for our upcoming “TwistTies” laser cut flexible turnout tie strips, I had to build and scenic a complete curved turnout. Once complete, I took several pictures of it from different angles, and settled on a couple of “keepers” that would be used in the documents.

There were a few others I liked, so I thought I would put them up here.

1
Image copyright 2005 Tim Warris

This is a #8 curved turnout that was built with the new TwistTies. More on those later….

Posted by: | 08-15-2005 | 08:08 AM
Posted in: Uncategorized

2 Comments »

  1. Is there going to be a curved turnout Assembly Fixture in the future?
    regards
    Mark

    Comment by Mark Damien — 8/26/2005 @ 9:54 pm
  2. I know that Tim has been working on a design. No idea when it might be released however.

    Comment by Ron Warris — 8/27/2005 @ 10:12 am

Comments RSS TrackBack URI

 

Leave a comment